18
Planning the Installation
Selection of Antenna Installation Site
The installation of v240C requires extreme precaution and safety measures given its
size and weight. Failure to follow the correct installation process may lead to injury
to the installer and/or cause damage to the system.
In order to maximize the performance of the system, a thorough review of this
installation guide is strongly recommended, as well as executing the installation
process as it is noted on this manual.
The system should be placed where there would be no blockage that would interfere
the signals. A safe mounting place should be selected for given its heavy weight
and size.
• System Cables
Before installing the system cables, you need to take the following points
into consideration.
1. All cables need to be well clamped and protected from physical damage and
exposure to heat and humidity.
2. Remember to observe the minimum bend radius of the selected cable.
3. Where a cable passes through an exposed bulkhead or deck-head, a watertight
gland or swan neck tube should be used.
• Power Requirements
You need to follow the power requirements to avoid damage the system.
Intellian v240C is designed to work on a power supply between 90-260V AC.
• Extending the Cables
The cables that have been supplied with your Intellian system should be of adequate
length to complete the installation on most boats.
• Power Cable
This cable supplied at a length of 10m.
• RF Cable
This cable is supplied at a length of 30m as an optional item. If a longer length
is required you should replace this cable with an extended RF cable supplied by
Intellian Technologies.
NOTE:
Exceeding the indicted cable lengths will result in reduced performance of
your system.
To Next Page
Loading...
Need help?
General