72
Installation Settings
During the rst time installation, it is required to setup the installation settings.
Installation Menu
Latitude & Longitude
Gyro type
Select satellite
Setup Mode
SETUP MODE ?
YES NO
1. Press LEFT arrow key to move cursor to YES and press OK key to enter SETUP Mode.
+ANTENNA +SATELLITE
+SYSTEM
+INSTALLATION
2. Press arrow keys to move cursor to INSTALLATION menu and press OK key to enter it.
SELECT SATELLITE
[1] ASIA6AH 125.00E
3. Press UP and DOWN arrow keys to select the satellite that you wish to track and press OK
key to load the selected satellite.
LATITUDE LONGITUDE
37.00N 126.53E
4. Set the current LATITUDE and LONGITUDE
Press LEFT and RIGHT arrow keys until the desired character is underscored (selected).
Press UP and DOWN arrow keys to increase or decrease the value. Or press NUMBER keys
to set the desired value directly. Press OK key to set the parameter.
GYRO TYPE BOW OFFSET
NMEA 000
5. Set the ship’s GYRO TYPE* and BOW OFFSET.
A search pattern 1 or 3 will be initiated according to which Gyro Type is selected and the
existence of the gyro input. Ensure that the supported Gyro Type is set correctly.
For v240, if the ship’s gyrocompass output is
Step-by-Step (SBS) or Synchro, separate purchase of a gyro converter is required.
NOTE: A search pattern 1 will be initiated automatically if the gyro input does not exist and the gyro
type is selected other than GROUND test.
The BOW OFFSET is to offset the angle difference between the antenna’s bow and the ship’s bow
(Range: 0-360°)
NOTE: The bow offset will not be saved automatically if Search 1 pattern is initiated. In this case,
the antenna will need to retarget the desired satellite using Search 1 every time if the antenna restarts.
To Next Page
Loading...
Need help?
General