Interlogix Simon XT Installation Guide

The following table below describes the LED functions.
LED Function
L1
Error LED. Flashes one to eight times in an eight-second
interval to indicate the specific error. See LED L1 (red)
for errors and common fixes.
L2
Panel Communication and Z-Wave status messages.
Flashes every time the module communicates with the
panel and flashes in patterns to indicate Z-Wave status.
L3
LTE Communication. Flashes every time the LTE signal
level is checked and when packets are exchanged with
Alarm.com.
L4
LTE Signal Level. Flashes zero to five times to indicate
signal strength, or toggles on/off slowly when
communicating with Alarm.com servers.
L5 Z-Wave Error LED.
LED details
LED L1 (red)
L1 flashes when there is an error. The number of flashes indicates the error number. If there are two or more errors at
the same time, the errors will flash one after the other. The LED will stay off for at least four seconds between errors.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Panels/Interlogix_Simon_XT/Interlogix_Simon_XT_…
Updated: Tue, 31 Mar 2020 20:51:49 GMT
9

Interlogix Simon XT Specifications

Power

power requirements	6V nominal
standby current	30mA (10mA in PowerSave Mode)
peak current	1.7 A

Operating Environment

operating temperature	32 to 120°F (0 to 49°C)
storage temperature	-30 to 140°F (-34 to 60°C)
max. relative humidity	90% non-condensing

Dimensions

height	4 1/16 in.
width	1 7/8 in.