To Next Page

To Previous Page

Power Supply Function

6. Press the Left/Right key to select Run and press [Enter] to run the battery

test.

This product supports Sense anti-reverse function. If you reverse the

Sense cables, the VFD will display a negative voltage value, and you can-

not turn on the output at this time. It can only be turned on after the cables

are properly connected.

7. Based on the selected trigger method, perform the trigger operation.

The trigger method of the battery test is consistent with the trigger method

of the List function, that is, the List trigger source is also effective for the

Battery function.

If you want to stop running during the battery test, you can do the following:

Press the composite keys [Shift]+[I-set] (Function) on the front panel to enter

the function menu.

At this point, the interface will prompt whether to stop the running of the Func-

tion, you can press the Left/Right key to select Stop, then the running will be

stopped, and the Function menu item will be displayed, you can re-enter the

Function menu for editing; if Reset is selected, it means to stop the present run-

ning and return to the main interface to wait for the next trigger operation.

4.6.3 Built-in Waveform Function

This series power supply supports built-in waveforms for user to execute the

test directly. The protocols/standards involved in the built-in waveforms include

the following:

• DIN40839

• ISO16750-2

• ISO21848

• SAEJ1113–11

• LV123

• LV124

This series 10V model do not support built-in waveform function.

ITech IT-M3900C Series User Manual

Questions and Answers: