Step1. Press key.
Step2. Select >MAX VOLT by using▲ and ▼ key.
Step3. Press key.
Step4. Change the voltage value by using numeric keys to or ▲and ▼key.
Step5. Press key.
Enter
Enter
Menu
0
9
Note: After you setting the maximum voltage value, the output voltage
setup should be in the range from 0 volt to maximum voltage. The default
maximum voltage is the full voltage range of its model.
Note: Default selection is ON and the output state is always OFF state.
Note: Default setting is ON and the output voltage is 0 volt.
■ Initiating the Output state(>INIT OUT)
This instruction can initiate the output state when the power supply is powered on. If you
select ON, the power supply will initiate the output to OFF state when the power supply is
powered on. If you select OFF, the output will remain the same state as last time you turned
off the power supply.
■ Initiating the Output Voltage (>INIT VOLT)
This instruction can set the initial output voltage. If you select ON, the power supply will
initiate the output voltage to 0 Volt when the power supply is powered on. If you select OFF,
the output voltage will remain as the same volts as the last time you turned off the power
supply.
Chapter 3 Front-panel Operation
22 USER’S GUIDE
To Next Page
Loading...
Need help?
General
