Step1. After you setting an output state (CV value, CC value and Maximum voltage), press
key.
Step2.Use the numeric keys to or ▲ and ▼ keys to select the memory location (the
range is 1 to 16) which you want to store in.
Step3. Press to conrm the memory location.
Step4. Press key.
Step5. Use numeric keys to or ▲ and ▼ keys to select the states which you want to
recall.
Step6. Press key to conrm. Then the saved settings will come on.
Enter
Enter
Save
Recall
9
9
0
0
Note: 1. If the function keys were locked by password, you need to enter
the correct password after you press function keys (V-set, I-set, Save,
Recall and Menu), then you can do the settings.
2. If you want to cancel a function operation (V-set, I-set, Save,
Recall or Menu), just press key to exit.
Esc
3.5 Menu Operation
■ Set Maximum voltage (>MAX VOLT)
Please be well known that the Max voltage value should be in the range of each type of
IT68xx Power supply.
3.4 Saving and Recalling Operation
You can store up to 16 different output states in storage register locations (1 to 16). Each output state
includes Constant voltage value, Constant current value and Maximum output voltage value. When shipped
from factory, storage locations “1” through “16” are empty. You can recall the saved settings by Recall
function.
Chapter 3 Front-panel Operation
USER’S GUIDE 21
To Next Page
Loading...
Need help?
General
