2. Press the Timer button. The Timer On indicator light will illuminate. This indicates that the
Auto Start function is initiated. (If you press the Timer button again, the Timer Off indicator
light will illuminate.)
3. Press or hold the left < and right > buttons to enter a time interval between 0.0 and 24 hours.
Time will increase or decrease in 0.5 hour increments up to ten (10) hours, and thereafter in one
(1) hour increments up to 24 hours.
4. The selected start time will show in the LCD display in a few seconds. The LCD display will then
automatically revert to showing the room humidity level.
5. To program an automatic stop time, press the Timer button again (the Timer Off indicator light
will illuminate) and repeat the steps above.
• Setting Auto Stop When Unit is Running
1. Press the Timer button. The Timer Off indicator light will illuminate. This indicates that the Auto
Stop function is initiated.
2. Press or hold the left < and right > buttons to enter a time interval between 0.0 and 24 hours.
Time will increase or decrease in 0.5 hour increments up to ten (10) hours, and thereafter in one
(1) hour increments up to 24 hours.
3. The selected stop time will show in the LCD display in a few seconds. The LCD display will then
automatically revert to showing the room humidity level.
NOTE:
• When the Auto Start and Auto Stop times are set within the same program sequence, the Timer On/Off
indicator lights illuminate together signaling that both on and off times are now programmed.
• Turning the unit on or off at any time or adjusting the timer setting to 0.0 will cancel the Auto
Start/Stop function.
• When LED display window displays the code P2, the Auto Start/Stop function will also be canceled.
Removing Collected Water
Collected water can be removed via 3 drainage options: manual drain, gravitational drain, and condensate
pump drain.
1. Manual
Moisture removed from the air is collected in the water reservoir. When the reservoir is full, the Full
indicator light will illuminate and the unit will stop operation. Remove and empty the reservoir. NOTE: If
the pump rod drops down when you remove the reservoir, push it back into its horizontal position or the
water reservoir will not install properly.
To Next Page
Loading...
Need help?
General
