Settings
6 720 643 409 (2010/03)
79
B Indicate the times between which the alarm buzzer
may not give out a sound.
All alarm buzzers are silent during a set interval.
>> Alarm indication control unit
>>> Block alarm buzzer
The setting applies only to the control unit's alarm
buzzer.
>> Alarm indication room sensor
>>> Block alarm buzzer
B Set if the alarm buzzer should be off or not.
The setting applies to Circuit 1and to a CANbus-
connected room sensor.
>>> Block alarm indicator lamp
B Set if the indicator lamp should be off or not.
The setting applies to all room sensors.
>> General alarm level
>>> Alarms and warnings
No means that alarms produce a signal on the general
alarm output. Yes means that alarms as well as warnings
produce a signal on the general alarm output.
15.12 Access level
Access level is Customer as standard: This level gives
you access to all functions that the user requires. The
installer also has access to the additional functions
required at installation.
15.13 Return to factory settings
B Select Return to factory settings and Yes to reset all
settings to the factory settings. Settings made by the
customer are not affected.
Factory setting No
Alternative No/Yes
Tab. 177Block alarm buzzer
Factory setting Yes
Alternative No/Yes
Tab. 178Block alarm buzzer
Factory setting Yes
Alternative No/Yes
Tab. 179Block status lamp
Factory setting No
Alternative No/Yes
Tab. 180Alarms and warnings
Factory setting No
Alternative Yes/No
Tab. 181Return to factory settings
To Next Page
Loading...
Need help?
General
