40
Environment / disposal
HMC300 – 6 720 813 192 (2014/10)
10 Environment / disposal
Environmental protection is a fundamental corporate strategy
of the Bosch Group.
The quality of our products, their efficiency and environmental
safety are all of equal importance to us and all environmental
protection legislation and regulations are strictly observed.
We use the best possible technology and materials for
protecting the environment taking into account of economic
considerations.
Packaging
We participate in the recycling programmes of the countries in
which our products are sold to ensure optimum recycling.
All of our packaging materials are environmentally friendly and
can be recycled.
Old electrical and electronic appliances
Electrical or electronic devices that are no
longer serviceable must be collected
separately and sent for environmentally
compatible recycling (in accordance with the
European Waste Electrical and Electronic
Equipment Directive).
To dispose of old electrical or electronic
devices, you should use the return and collection systems put
in place in the country concerned.
Technical terms
Setback phase
A time slot during automatic mode, with Setback operating
mode.
Automatic mode
The heating system is heating in accordance with the time
program and an automatic changeover takes place between
operating modes.
Operating mode
The operating modes for heating are: Heating and Setback.
They are shown with the symbols and .
The operating modes for hot water heating are: DHW, DHW
reduced and Off.
For each mode (with the exception of Off) it is possible to set a
temperature.
Frost protection
Depending on the selected frost protection, the heat pump will
turn on when the outside and/or room temperature reaches
below a certain set threshold. Frost protection prevents the
heating system from freezing up.
Required room temperature (also desired or set
temperature/set room temp.)
The room temperature to be achieved by the heating system. It
can be set individually.
Default setting
Values permanently saved in the programming unit
(e.g. complete time programs) that are available at any time
and that can be reinstated according to demand.
Heating phase
A time slot during automatic mode, with Heating operating
mode.
Hybrid system
Heating system from factory set heat sources with built-in
optimised control, which are offered as separate installation
modules (e.g. heat pump with conventional heat source as
additional heat). The system produces hot water for the
heating of a building, and where appropriate hot water heating.
Child lock
The settings in the initial menu and in the menu can only be
changed when the child lock (button lock) has been removed
( page 11).
To Next Page
Loading...
Need help?
General