en-57
JACOBSEN AR3
SAFETY, OPERATORS & MAINTENANCE MANUAL
11 TROUBLESHOOTING
11.2.2Step Cutting
NOTE: Arrow indicates direction of travel.
Step cutting occurs when grass is cut taller on one
side of a cutting unit than the other or on one side of
mower to the other. This is usually caused by
mechanical wear or an incorrect roller or deck caster
adjustment.
Probable Cause Remedy
HOC (height-of-cut) settings are different from
one side of a cutting unit to the other or from one
cutting unit to another.
Check HOC adjustment of cutting units. (Refer to Parts &
Maintenance Manual.)
Worn roller bearings or deck caster wheels. Check/replace roller bearings and/or deck caster wheels.
Cutting unit movement is restricted. Check/remove cutting unit movement restriction.
Variations in turf density Change mowing direction.
Machine ride height is uneven side to side.
Check/adjust proper tire inflation pressure. (Refer to Parts
& Maintenance Manual.)
Cutting unit height is uneven side to side. Check/adjust for even mower weight distribution.
To Next Page
Loading...
Need help?
General
