en-3
The Jacobsen AR3 is a Diesel engined self propelled Rotary mower. The hydraulic systems are for the
traction drive, the cutting unit lift and the lower and cutting unit drives and steering.
IMPORTANT: The reliability and cutting performance of this machine will depend on the its care and use.
Failure to operate and maintain within the practices given in this manual will shorten component life and affect
cutting performance.
This SAFETY AND OPERATORS MANUAL is part of the machine and must stay with the machine always.
Suppliers of both original and used machines need to keep the documentation that comes with the machine.
You must use the machine to cut the grass only and not for any other purpose. Compliance with the conditions
of operation, service and repair specified by the manufacturer, are understood to be part of the correct use.
ALL operators MUST read through this manual and understand the Safety Instructions, controls, lubrication
and maintenance procedures.
Make sure that you obey all safety and road traffic regulations.
You must not make any changes to the machine that the manufacturer does not approve. This type of change
can release the manufacturer from the liability for any damage or injury.
Discard worn parts, taking note of the environmental result, use the systems available in the country where
the machine is used. When the machine is at its end of life, there are guidelines in this manual for the removal
of the machine from use.
Use only Ransomes Jacobsen Genuine spare parts to make sure that European conformity is controlled.
2006/42/EC
These instructions are the Original instructions confirmed by Ransomes Jacobsen Limited
INTRODUCTION 2
To Next Page
Loading...
Need help?
General
