Jacuzzi J-Sha Mi User Manual

59
In the event of difficulty...
THE HYDROMASSAGE DOES NOT START
VV First of all, check that the main switch on the power supply
line of the tub is on and that there is not a power outage. Also
make sure you have complied with the instructions provided in
the relative chapter. Make sure the remote control is pointed at
the receiver when confirming function start-up.
If there are any other irregularities, please refer to the following
instructions.
I Defects concerning the electronics box
• Pump does not start
• The LED for the key on the receiver flashes.
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the
screenshot as indicated.
VV Contact a Jacuzzi
®
service centre .
To return to normal remote control display, press any key.
I Insufficient water level
• The water in the tub is below the required level and the pump
is stopped.
• The LED for the key on the receiver flashes.
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the
screenshot as indicated.
VV You will need to add the required amount of water and re-
peat the steps described in the chapter on the hydromassage.
Make sure you turn the remote control off and then back on.
I Incorrect position of distributor valve
During selection of the various hydromassage cycles, if this
valve is incorrectly positioned, the cycle will not proceed.
• You will not be able to select the desired type of hydromas-
sage and the display will continue to show “Waiting Posi-
tion”.
• The LED for the key on the receiver flashes.
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the mes-
sage "E RROR POS ITION" as in the figure.
VV Contact a Jacuzzi
®
service centre .
THE HYDROMASSAGE STOPS BY ITSELF
VV First of all, check that the main switch on the power supply
line of the tub is on and that there is not a power outage. Also
make sure you have complied with the instruction provided in
the relative chapter.
Each hydromassage cy cle has its own duration. At the end
of that period, the hydromassage shuts down automatically.
Refer to the relative chapter to re-star t it.
If there are any other irregularities, please refer to the following
instructions.
ERROR
POSITION
ATTENTION
PLEASE
16:30
ATTENTION
PLEASE
16:30
ELECTRONIC
PROTECTION
E1
ATTENTION
PLEASE
16:30

Jacuzzi J-Sha Mi Specifications

General

Brand	Jacuzzi
Model	J-Sha Mi
Category	Hot Tub
Language	English