Janus G3 User Manual

NOTE: If you are on a phone line that requires a “9” or another digit to
call the answering service, enter a # after the 9. This will insert a 4
second pause. EXAMPLE: # 09 # 5551212 * #.
4. Enter # 1 (enter second phone number to be programmed) * #. (Optional)
5. Enter # 2 (enter third phone number to be programmed) * #. (Optional)
6. Enter # 3 (enter fourth phone number to be programmed) * #. (Optional)
7. Enter # 7 and listen for the single beep. At the beep, record the
location message by speaking into the touch tone phone handset or
into the microphone of the G3 phone when using the keypad to
program. Enter 0 to end. If you want to listen to the location message
without changing it, enter # 8.
8. Enter # * 1180183 * # and listen for three beeps (enables voice prompt
messages).
9. Enter # # to hang up the phone.
Optional Programming Instructions
PURPOSE: To Eliminate Autodialing:
To disable the G3 unit from dialing a phone number (used on a ring down
telephone line).
• Enter # 94851 or #9000000 and listen for three beeps.
• Enter # 0 * #, listen for three beeps, enter # 1 * #, listen for three beeps.
• Enter # 2 * #, listen for three beeps, enter # 3 * #, listen for three beeps.
• Enter # * 1180180 * #, listen for three beeps. (Optional)
• Enter # # and hang up.
PURPOSE: To Disable the Voice Prompt Message:
To disable the voice prompt from saying: “Elevator call, at the tone press
one to talk, press two for location”.
• Enter # 94851 or #9000000 and listen for three beeps.
• Enter # * 1180180 * #, listen for three beeps.
• Enter # # and hang up.
CAUTION: This option cannot be used with two or more number dialing.
PURPOSE: To Disable Voice Prompt Message and Delay Voice
Location Message:
To disable the voice prompt and have the location message play
automatically every 19 seconds.
• Enter: # 94851 or #9000000 and listen for three beeps.
• Enter: # * 1180185 * # and listen for three beeps.
• Enter: # # and hang up.
PURPOSE: To Enable Voice Prompt Message (DEFAULT):
To enable the voice prompt message to say: “Elevator call, at the tone
press one to talk, press two for location”.
• Enter # 94851 or #9000000 and listen for three beeps.
• Enter # * 1180183 * # and listen for three beeps.
• To program location message, see programming instructions.
• Enter # # and hang up.
9

Janus G3 Specifications

General

optional AC adapter	9-12VDC/VAC @ min. 200mA
operating current range	18mA to 55mA
phone line voltage on-hook	24VDC to 70VDC (nominally 48VDC)
phone line voltage off-hook	8 to 20VDC (nominally 14VDC)
ring sensitivity	30 - 120VAC RMS
operating temperature range	32 to 122F (0 to 50C)
storage temperature range	-4 to 158F (-20 to 70C)
relative humidity	Up to 95% (non-condensing)
frequency response	550Hz - 3400Hz +/- 3db.
operational loop impedance	600 ohms

Weight and Dimensions

size	5.5in x 3.2in x 0.75in (140mm x 81mm x 19mm)
weight	0.37lbs (0.17Kg)