37
VTX A12 | Rigging Manual
9 - DEPLOYING A12 SYSTEMS
The suspension of a VTX A12 system by a trained technician should be a simple and straightforward process. Follow all steps below and
the array will suspend safely and efficiently. Failure to follow the steps as outlined may damage equipment and/or result in a potentially
hazardous condition.
9.1 PRESELECT THE ANGLES
Suspending a VTX A12 array is a simple and straightforward process. Carefully execute these steps to correctly and safely suspend an
array.
STEPS:
• Using the quick release pins (QRPs) located on the Angle Selection Panel, select the desired inter-enclosure splay angles for
all cabinets. Remove each QRP from its STORAGE position (10 degrees) and move it to the desired position, as indicated on
the label. If the desired angle is 10 degrees, the QRP does not need to be moved.
• Pull up the top rigging arms with your hands until they are fully engaged. This makes connecting stacks together much easier.
1 2
1
2
To Next Page
Loading...
Need help?
General
