9
The JRDG CONTINUUM
Integrated Amplifier has been
designed to operate at the
highest level of efficiency and
performance in any normal
operating situation; however,
there are a few important use
and care principles that must
be kept in mind when operating
the amplifier:
• Do not expose the amplifer
to rain, moisture, or excessively
damp conditions.
• Due to auto-ranging circuitry and
dual-stage voltage regulation, the
audio performance of the
CONTINUUM 500 will not be
affected by any voltage uctuations
within the operating voltage range.
The CONTINUUM 500 Integrated
Amplier can be operated at any
mains voltage over the range of 85
to 265 VAC without any adjustments
necessary. The CONTINUUM 250
Integrated Amplier requires internal
voltage change.
• The CONTINUUM Integrated Amplier
must not be modied in any way,
other
than according to ofcial service
bulletins from JRDG. Otherwise, the
factory warranty will be immediately
voided.
• Be sure the amplier is muted
(red front panel indicator light on)
before
connecting or disconnecting
any
interconnect cables.
• When operating the CONTINUUM,
a
properly grounded AC receptacle
should be used. A potential shock
hazard may result if the supplied
3-wire, grounded AC cable ground leave power switch ON and plug/
terminal is defeated or lifted or unplug unit from wall.
the unit is connected to a 2-wire
ungrounded AC outlet.
• The CONTINUUM is designed to per-
form
optimally with no adjustments
or
maintenance for the lifetime of the
product. Do not attempt to open the
bottom cover of the amplier and
refer all service issues to qualied
personnel. The voltages inside the
CONTINUUM can be hazardous.
• Because of the energy efciency
of the CONTINUUM, there is no need
to unplug the unit when not in use;
however, the amplier can be muted
if desired. The rear panel AC mains
switch is not intended for daily use.
Switch failure may result. Simply
To Next Page
Loading...
Need help?
General
