To Next Page

To Previous Page

VM9726BT

iPod®/iPhone® OPERATION

NOTE: Be sure your iPod

has the latest Apple rmware installed to avoid

connectivity issues.

Accessing iPod® Mode

This unit is Made for iPod® and iPhone®. You can control your iPod® via touch screen

to access Playlist, Artist, Albums, Songs, etc. Supported models include, but are not

limited to the following:

• iPhone® 4S / 4 / 3GS / 3G and 1st Generation

• iPod touch® 4th / 2nd and 1st Generation

• iPod nano® 6th / 5th / 4th and 3rd Generation

• iPod classic® and iPod® with video

The unit will automatically switch to iPod® mode when an

iPod®

, iPod touch® or

iPhone® is plugged into the front or rear USB connector.

NOTE: For basic iPod® connectivity, you can use the white 30-pin to USB iPod® cable

that came with your Apple device . For iPod® video or photo playback, you must

purchase the jLink-USB cable.

To return to the iPod® menu from any other source menu, touch SRC on the front

panel until the iPod® menu appears on the screen, or choose the iPod® icon from

the source menu (only available when an iPod® or iPhone® is connected to the USB

connector).

NOTE: To transmit the video from your iPod® to the VM9726BT screen, you must set

the following options through the iPod® video settings menu:

TV Out = On, TV Signal = NTSC, and Widescreen = On.

NOTE: After disconnecting your iPod®, the VM9726BT will always return to the last

mode accessed when the iPod® is plugged back into the unit.

Jensen VM9726BT User Manual

Other manuals for Jensen VM9726BT