Jetson Atlas User Manual

16
1.2 Attaching the Seat
1. PULL OPEN THE LATCH ON THE SEAT CLAMP.
2. LOCATE THE "MINIMUM INSERTION" MARK ENGRAVED NEAR THE BOTTOM OF THE SEAT POST.
3. HOLD THE SEAT IN POSITION ABOVE THE BIKE.
4. LOWER THE SEAT POST THROUGH THE CLAMP AND INTO THE SEAT TUBE UNTIL THE MINIMUM INSERTION MARK IS
BELOW THE CLAMP. IF THE CLAMP OPENING IS TOO NARROW TO RECEIVE THE POST, YOU CAN WIDEN IT BY TURNING
THE KNOB ON THE CLAMP COUNTERCLOCKWISE WHILE HOLDING THE LATCH STEADY.
5. WHILE HOLDING THE SEAT AT THE DESIRED HEIGHT, CLOSE THE LATCH ON THE CLAMP.
SEAT POST
MINIMUM INSERTION MARK
CLAMP LATCH
SEAT CLAMP
CLAMP KNOB
(opposite side- not shown)

Jetson Atlas Specifications

General

Brand	Jetson
Model	Atlas
Category	Scooter
Language	English