TEC3000 Series Single- or Two-Stage Economizer Thermostat Controllers Installation Instructions
41
Technical Specifications
TEC3000 Series Single- or Two-Stage Economizer Thermostat Controllers
Power Requirements 19 to 30 VAC, 50/60 Hz, 4 VA at 24 VAC nominal, Class 2 or
safety extra-low voltage (SELV)
USB Port Power Rating 120 to 250 mA current draw supported
Relay Contact Rating 19 to 30 VAC, 1.0 A maximum, 15 mA minimum, 3.0 A in-rush, Class 2 or SELV
Binary Inputs Voltage free contacts across terminal COM to terminals BI1 or BI2
Analog Inputs Nickel, platinum, A99B, 2.25k ohm NTC, 10k ohm NTC, 10k ohm NTC Type 3
across terminal COM to terminals R SEN
Temperature Sensor Type Local 1k ohm platinum sensor
Wire Size 18 AWG (1.0 mm diameter) maximum, 22 AWG (0.6 mm diameter) recommended
MS/TP Network Guidelines Up to 100 devices maximum for each Network Automation Engine (NAE);
4,000 ft (1,219 m) maximum cable length. Refer to the MS/TP Technical Bulletin for
the Metasys, FX, or Verasys system installed.
Temperature
Range
Backlit Display -40.0°F/-40.0°C to 122.0°F/50.0°C in 0.5° increments
Heating Control 40.0°F/4.5°C to 90.0°F/32.0°C
Cooling Control 54.0°F/12.0°C to 100.0°F/38.0°C
Accuracy Temperature ±0.9F°/±0.5C° at 70.0°F/21.0°C typical calibrated
Minimum Deadband 2F°/1C° between heating and cooling
Occupancy Sensor Motion
Detection (Occupancy Sensing
Models)
Minimum of 94 angular degrees up to a distance of 15 ft (4.6 m);
based on a clear line of sight
Ambient
Conditions
Operating 32 to 122°F (0 to 50°C); 95% RH maximum, noncondensing
Storage -22 to 122°F (-30 to 50°C); 95% RH maximum, noncondensing
Compliance BACnet
International
BACnet Testing Laboratories™ (BTL) 135-2001 Listed BACnet Application Specific
Controller (B-ASC)
United States UL Listed, File E27734, CCN XAPX, Under UL60730
FCC Compliant to CFR 47, Part 15, Subpart B, Class B
Canada UL Listed, File E27734, CCN XAPX7, Under E60730
Industry Canada, ICES-003
Europe CE Mark – Johnson Controls declares that this product is in compliance
with the essential requirements and other relevant provisions of the EMC Directive
and the RoHS Directive.
Australia and
New Zealand
RCM Mark, Australia/NZ Emissions Compliant
Shipping
Weight
Models without
Occupancy
Sensor
0.75 lb (0.34 kg)
Models with
Occupancy
Sensor
0.77 lb (0.35 kg)
The performance specifications are nominal and conform to acceptable industry standards. For application at conditions beyond these
specifications, consult the local Johnson Controls office. Johnson Controls shall not be liable for damages resulting from misapplication or
misuse of its products.
To Next Page
Loading...
Need help?
General
