JR PCM9X II Programming

www.modelflight.com.au – World’s best source of JR products
Step #28 Flap Ra
t
e, Flape
r
on Mix and Fli
g
ht Mode Dela
y
(
con
t
.
)
Flight Mode Delay Adjust The flight mode
delay adjust menu allows the programming of a delay
from 0 to 2 seconds. This delay affects the flap, flaperon
and elevator presets when
switching from one flight mode to another. When
inhibited, no delay occurs and the servo immediately
transitions from one preset trim position to another
w
hen the flight modes are switched. With a delay
programmed, the transition is smooth relative to the
delay time. A break-off function is available that can be
programmed to override the delay, based on a selected
eleva
t
or stick posi
t
ion. For this setup, we
w
ill program a
1.5
second delay for cruise.
In FUNC. L IST rotate the Selector until FM DE L A Y is
highlighted. Press the Selector to access the Flight
Mode Delay Adjust menu. Rotate the Selector to
highlight the cruise delay value then press the Selector
to access this value. Rotate the Selector to adjust the
value to 1.5s (seconds) Press the Selector to store the
value. Press the LIST button to return to the Function
Mode screen.
Step #29-
A
ile
r
on-
t
o-
R
udde
r
Mix
In FUNC. L IST rotate the Selector until A I L ⁄ RUD M is
highlighted. Press the Selector to access the Aileron-to-
rudder mix menu. Rotate the Selector to highlight the
cruise left value then press the Selector to access that
value. With the flight mode switch in the middle cruise
mode, give a full left aileron command and rotate the
Selector to achieve the desired left rudder throw.
Pressing the Selector will store the value. Now rotate
the Selector to highlight the launch right value and
adjust it to the desired position. Press the LIST button
to return to the Function Mode screen.
21 Sail
p
lane P
r
o
g
r
ammin
g
Guide

JR PCM9X II Specifications

General

Brand	JR
Model	PCM9X II
Category	Receiver
Language	English