9 Sailplane Section
Motor Function
The motor function can be assigned to operate from
several different switches, buttons or the throttle stick.
In device select, highlight MOTO and press the Selector
to access the available switches that can be
programmed to operate the motor.
Select the desired switch by highlighting it and press
the Selector.
Note: If dual flaps are activated in Wing Type in system
mode, the motor function is not assigned to a channel.
It will be necessary to use a programmable mix to mix
MOTO to any open auxiliary channel in order to operate
the throttle when dual flaps are activated. Also see
Motor Hold on page 21 for more details.
AIL D/R Aileron dual rate switch
ELE D/R Elevator dual rate switch
RUD D/R Rudder dual rate switch
BTFL SW Mix (Butterfly) switch
FMOD SW Right 3-position
Flight Mode switch
AUX4 SW Left 3-position Flap switch
MOTO SW Gear (Motor) switch
TIME SW Trainer/Snap Roll/Timer switch
SPOI ST Spoiler stick
Flap and AUX Functions
The Flap and Auxiliary functions can be assigned to
operate from several different switches, levers or the
throttle stick. In device select, highlight the desired flap
or aux function and press the Selector to access the
available switches that can be programmed to operate
each function.
Select the desired switch by highlighting it and press
the Selector.
Refer to the table under Motor Function above for a
mapping of menu switch names to the actual switch
labels.
To Next Page
Loading...
Need help?
General
