– 116 –
The check program offers 13 functions as specified below.
No. Pictograph Description
Independent head operation
Carry out independent head operation.
Used to check shuttle oil amount and others.
Center knife check
Check the independent motion of the center knife motor and the elevating
conditions of the center knife.
Flap sensor adjustments
Adjust and correct the flap sensor mounting position.
Detection of reflection seal deterioration
Check deterioration (if any) in the reflection seal for flap detection, which is
stuck to the folding plate.
Stacker adjustments
Perate only the stacker independently.
Unit aging
Repeat sewing operation.
Input check
Check the sensor input state.
Output check
Check the solenoid valve output.
Touch panel correction
Correct the touch panel and button display positions.
LCD check
LCD dot defect check
Confirmation of needle entry position
Adjust the clearance between Garment body clamp and folding plate and the
needle.
Adjustment of binder height
Adjust the binder height.
Head stop angle adjustment
Adjust the upper needle stop angle.
To Next Page
Loading...
Need help?
General
