18
6. Open the completed
buttonhole, using the
seam ripper.
Stopper pin
Corded Buttonholes
Sewing a cord into the buttonholes will
prevent them from becoming loose and
they will last longer. Buttonhole twist
thread may be used for cording.
In the eventof buttonholing failure
In the case where a buttonholing
failure has arisen when the machine
has been sewing the right-parallel
seam of the buttonhole.
In the case where a buttonholing
failure has arisen when the machine
has been sewing the left-parallel
seam of the buttonhole.
1. Lift the presser foot and undo the seam.
2. Select the “ ” using the pattern
selector dial.
3. Run the machine idle by approximately
10 stitches.
4. Select the “ ” using the pattern
selector dial.
Then, perform the buttonholing again from the
sewing start position.
1. Lift the presser foot and undo the seam.
2. Select the “ ” using the pattern
selector dial.
Then, perform the buttonholing again from the
sewing start position.
How to set the cord.
(Front)
CAUTION: Make sure to turn off the machine before
changing the presser foot.
(back)
Cord
When you sew buttonholes with cording, pass the cord through the end of the
buttonhole foot and knot the ends of the threads at the front. Then, attach the
buttonhole foot to the presser bar and sew the buttonhole. Pull the cording tight
into the sewn buttonhole and cut off the excess cord.
To Next Page
Loading...
Need help?
General
