JUKI MB-1373 User Manual

– 14 –
(3) Attachment for the second process of wrapped-around buttons (Z035)
(INSTALLATION)
Remove the button clamp mechanism assembly, but-
t
on clamp pressure adjusting bar and feed plate from
the machine and install attachment for the second
process of wrapped-around buttons
1
. When you
install a Z035 attachment, you must remove also the
L-shaped lifting rod.
Insert moving knife push-back spring
3
, washer
4
, cushion
5
and washer
4
in spring guide shaft
2
in this order. Make certain that the stop-motion
mechanism has completely engaged, and install the
attachment assembly in place in the way that cush-
ion
5
comes in close contact with the surface of the
machine arm without play.
(ADJUSTMENT AND OPERATION)
1) Loosen screw
6
and adjust the thread shank length by mov
ing guide (large)
7
and guide (small)
8
in
line with the point of needle entry.
2) Set a button (tilt it slightly for easy insertion) and pass the thread as the arrow shows.
3) Set the lengthwise feed to “0”.
(4) A
ttachment for snaps (Z037)
(INSTALLATION)
Remove the button clamp mechanism assembly
and the feed plate. Set both the crosswise feed and
lengthwise feed graduated plates to “4 mm”. Install
snap clamp feed plate
1
in the way that the needle
drops evenly at four corners of its square opening.
Install snap attachment assembly
2
on the machine,
place a snap on the snap clamp jaw levers and make
sure that the needle drops accurately
in each hole in
the snap. If necessary. loosen hex head screws
3
and adjust the position accurately. Lastly, make sure
that the concave section on the bottom face of snap
clamp slide guide
4
accurately matches the convex
section on snap clamp feed plate
1
.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
1
(Z035)
2
5
4
3
1
2
4
3
7
8
6

JUKI MB-1373 Specifications

General

Brand	JUKI
Model	MB-1373
Category	Sewing Machine
Language	English