JUKI MO-1000 User Manual

23
8
A
注意
A
B
8
A
注意
Cutting width
Switch the machine off (Power
switch to “0”)
Disconnect machine from electricity
supply.
• Raise the upper knife.
• Turn cutting width adjustment dial in the
desired direction.
• Lower upper knife.
1 = 3–5 mm seam width
2 = 4–6 mm seam width
3 = 5–7 mm seam width
4 = 6–8 mm seam width
5 = 7–9 mm seam width
The position of the lower knife determines
the width of the seam.
Reduce the cutting width if the edges of
ne fabric curl up when being sewn (A).
Increase the cutting width if the loops
seem to be too loose (B).
宽幅与布料剪切宽幅的调节
在调整下切刀位置时，请关闭电源开关
•
抬升上切刀。
•
按照想剪切的宽度来调整剪切宽度调节
盘。
•
放下上切刀。
1=3 ～ 5mm 缝宽
2=4 ～ 6mm 缝宽
3=5 ～ 7mm 缝宽
4=6 ～ 8mm 缝宽
5=7 ～ 9mm 缝宽
下切刀的位置确定
通过下切刀的位置来确定缝制的宽度。
降低剪切宽度的话，细织物的边缘会被卷
进去（一）。
提升剪切宽度的话，线环会太松（B）。
Adjustments and settings /
缝迹长度的调整
WARNING
Do not carry out sewing with a
marking pin stuck in the material.
In addition, do not attempt to cut
anything other than fabric and
thread with the upper/lower knives.
Be aware that doing so can cause
needle break or personal injury.
警告
在缝制时请勿将珠针等留面料里，
以免造成机针或是切刀损坏。此外，
也请不要用上下切刀去剪切任何织
物或是线以外的任何物品。否则会
造成断针或是人身伤害。

JUKI MO-1000 Specifications

General

Brand	JUKI
Model	MO-1000
Category	Sewing Machine
Language	English