– 6 –
(3) Installing position of the needle clamp
Needle clamp connecting stud should fit with the bottom end of needle bar or be spaced within 0 to 0.5
mm.
(4) Adjusting the length of the lower looper holder (Applicable only to MO-6716D series)
The center-to-center distance should be 26 mm.
At this time, the clearance between the end surface of the arm and the neck of the ball should be 3.5mm.
26mm
3.5mm
Butt the needle clamp with the
bottom end of the needle bar.
0 to 0.5mm
Standard Adjustment
Standard Adjustment
To Next Page
Loading...
Need help?
General
