1. Press Enter. For the PP310, the BIOS configuration is updated and the device reboots.
The following upgrade script output is displayed for the PP310. The upgrade script
output for the PP332 is very similar, and you must respond to the same prompts.
Gathering system information.
* Please wait this could take up to 45 seconds.
Found:
System type PP310
Bios 2.21
Memory installed 1024 MB
Slot 0: Type T1E1
FPGA 0xea * needs 0xea
Slot 1: Type Serial
FPGA 0x73
Slot 2: Type FXS
FPGA 0x5010150
ID restored No
Hit return to continue...
Do you want to restore the ID from a CTPOS 4.6R7 or 5.4R3 system?
NOTE: For the PP332 processor, the BIOS version is 2.14 and a BIOS
upgrade is not required.
2. Enter y. The following output is displayed:
Please insert the old flash into the compact flash to USB
adapter and plug the adapter into the usb slot on the CPU.
Hit return when you are finished.
3. Insert the old (256 MB) CompactFlash card into the CompactFlash adapter (see
Figure 4 on page 17).
Figure 4: CompactFlash Adapter with CompactFlash Card Inserted
g015410
USB to CompactFlash adapter
256 MB upgrade CompactFlash card
4. Connect the adapter to the CTP2000 USB port.
5. Press Enter to indicate that you are finished inserting the CompactFlash card into the
adapter and connecting the adapter. Follow the onscreen instructions.
Got old CTPOS version: 4.6R7
Gathering old system information.
17Copyright © 2015, Juniper Networks, Inc.
Chapter 2: Upgrading the CTP2000 Series Device to CTPOS 7.x
To Next Page
Loading...
Need help?
General
