To Next Page

To Previous Page

Creating Classifier Control Lists ! 9

Chapter 2: Creating Policies

You configure CLACLs with a name and then values to match in the IP datagram

header. A CLACL does not include an action: actions take place when a match is

included in a policy list.

Classifier Control List Commands

Use the commands in this section to create or modify CLACLs.

atm classifier-list

! Use to create or modify a classifier control list that can only be use in ATM

policy lists.

! Use the following keywords to configure the list:

! traffic-class—Matches packets with a class that you defined using the

traffic-class command

! color

" green—Matches packets with color green, indicating a low drop

preference

" yellow—Matches packets with color yellow, indicating a medium drop

preference

" red—Matches packets with color red, indicating a high drop preference

! user-packet-class—Matches packets with the specified user packet class

value

! clp—Matches ATM CLP bits with the specified CLP value

! Example

host1(config)#atm classifier-list atmclassifier color red user-packet-class 10

clp 1

! Use the no version to remove the classifier control list.

VLAN ! Color

! Traffic class

! User packet class

! User priority

Table 4: CLACL Criteria (continued)

Type of CLACL Criteria

NOTE: Do not use the asterisk (*) for the name of a classifier list. The asterisk is

used as a wildcard for the classifier-group command.

Juniper E320 User Manual

Questions and Answers: