Remote Programming
20
DVD codes
The remote control is programmed with DVD codes for power on, power off, play, stop,
fast-forward, rewind, previous chapter, next chapter, tray open/close, and still/pause operation.
1) Find the DVD player brand from the list of codes shown below.
2) Slide the first 2-way selector switch to “TV” and the other 2-way selector switch to “DVD”.
3) Press and hold down the DISPLAY button.
4) With the DISPLAY button held down, enter the first code number listed with the 10 key pad.
5) Release the DISPLAY button.
6) Confirm the operation of the DVD player.
• If your DVD player does not respond to the first code, try the others listed. If it does not respond
to any code, try the Search Codes Function, on page 50.
• After you program your remote, some DVD buttons may not work properly. If some buttons do not
work properly, use the remote control which came with your DVDplayer.
D502/302/202 mini-IB 4/5/01 9:40 AM Page 20
To Next Page
Need help?
General
