JVC CA-D5T User Manual

To Play a Disc
This function plays the disc in the Unit continuously.
1. Prepare the discs.
Z. Press the DISC button (1-3) of the disc to play.
The first track of the selected disc will begin playing.
When the selected disc finishes playing, the next disc will begin playing automatically.
When the last disc has finished playing, the Unit will stop automatically.
=
”n
m
=
Lid
(1) When a DISC button is pressed while a tray is open, the open tray will close automatically and
Continuous Play playback begins from the first track of the disc.
To use Continuous Play from the first track of the disc selected by the disc marker, you do not need
to press a DISC button (1-3), just press the CD button (or > button on the Remote Control).
Playing order of discs
Q When playback starts from DISC-1, the playing order is DISC-1 -* DISC-2 + DISC-3. When
DISC-3 has finished, the CD Player selects DISC-1 (the disc marker is on) and stops.
Q When playback starts from DISC-2, the playing order is DISC-2 > DISC-3 + DISC-1. When
DISC-1 has finished, the CD Player selects DISC-2 (the disc marker is on) and stops.
{When playback starts from DISC-3, the playing order is DISC-3 > DISC-1 + DISC-2. When
DISC-2 has finished, the CD Player selects DISC-3 (the disc marker is on) and stops.
¢ If any of the disc trays are empty, the CD Player skips that disc tray and continues through
the remaining disc trays in the order shown above.
Note: If there is no CD in disc tray for the DISC button you pressed, the message “OPEN” appears
in the display and the disc tray automatically opens.
If there is no disc in the disc tray for the selected disc number, when the CD button (or the ® button
on the Remote Control) is pressed, playback begins from the next disc.
To stop play the disc, press the ll button (or the ™ button on the Remote Control) for the disc
number being played.
To stop play and remove the disc, press the & button (or the & button on the Remote Control) for
the disc being played.
To pause, press the CD button. The CD button and the Disc display will blink. (The Pause function
cannot be used with the button on the Remote Control.)
To cancel pause, press the CD button again. Play continues from the point where it was paused.
RESUME
When the STOP/CANCEL @ button (or the @ button on the Remote Control) is pressed during
playback, and the source is changed, the track number is memorized even when the power is turned
off. The next time the CD button (or the > button on the Remote Control) is pressed, play resumes
from the track where it was interrupted.
(2 To start playback from the first track, press the DISC button.
To Change Discs While Playing
You can replace a CD in a tray not being used, while another CD is playing.
7. Press the 4 button of the tray not being used.
The tray opens.
2. Replace the disc in the tray.
3. Press the 4 button to close the tray.
15

JVC CA-D5T Specifications

General

Brand	JVC
Model	CA-D5T
Category	Stereo System
Language	English