JVC CA-D5T User Manual

Standard Recording
REC
REC PAUSE
e
« G3 »
This is the basic method for recording any source. The CA-DST also has special ways for recording
CD to tape, and tape to tape, which save you time and effort, as well as give you some special
effects. ;
However, when you need to add a selection to a tape you have made, or are combining selections
from several sources on one tape, use the method described below; just substitute the source you
want into this procedure, such as a tape in Deck A, a CD, or the Tuner. You can also record from an
auxiliary source with this procedure.
To Record Any Sound Source To Tape
Follow these steps to record from any sound source onto a tape in Deck B.
Using the Unit
7. insert a blank or erasable tape into Deck B.
2. Press the REVERSE MODE button if you want to record on both sides of the tape.
Reverse Mode comes on.
{1 When using Reverse Mode, insert the tape so that it will be recorded in the forwards >
direction.
3. Check the recording direction for the tape.
Check that the direction indicator is the same as that for the tape in the tape deck. If the direc-
tions are different, press the TAPE button twice then press the STOP @ button.
{} When using Reverse Mode to record both sides of a tape, check that the direction indicator
is in the forwards » direction. If the direction indicator is not in the forwards > direction,
press the TAPE button twice then press the STOP @ button.
4. Prepare the source, by, for example, tuning in a radio station, loading CDs, or turning on
connected equipment.
5, Press the REC START/STOP button.
The Recording indicator light comes on and the CA-DST begins recording.
Using the Remote Control
7. insert a blank or erasable tape into Deck B.
2. Press the REC PAUSE button.
The Recording indicator light comes on.
3. Press the REVERSE MODE button if you want to record on both sides of the tape.
Reverse Mode comes on.
(} When using Reverse Mode, insert the tape so that it will be recorded in the forwards >
direction.
4. Prepare the source by, for example, tuning in a radio station, loading CDs, or turning on
connected equipment.
C_) C_) 5. Press the < or > button.
24
Recording starts in the direction of the button pressed.
{J When using Reverse Mode to record both sides of a tape, press the ® button.
If you are recording an AM (MW/LW) broadcast and you hear
interference, move BEAT CUT switch on the back panel from
position 1 (the normal mode) to position 2.

JVC CA-D5T Specifications

General

Brand	JVC
Model	CA-D5T
Category	Stereo System
Language	English