Loading Batteries into the Remote Control
Loading the batteries
Removing the batteries
0
If
the remote control has to be brought closer to the unit
to operate, it means that the batteries are wearing out.
Replace the batteries with new ones (AAA).
0
Insert the batteries according to the t s marks.
Be sure to insert the s
end first.
When removing the battery, do so from the t end.
0
If an error occurs while using the remote control,
remove the batteries and wait for five minutes. Load
the batteries again and operate the remote control.
CAUTION
0
Do not put the remote control in a place with an
exposure
to direct sun light or high temperature. It may
deformed due to heat, or the internal components may
be adversely affected resulting in fire hazard.
0
Remove the batteries from the remote control when
storing
the remote control. Storing the remote control
for a prolonged period without removing the batteries
can cause battery leakage.
0
Risk
of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the
instructions.
0
If you want to dispose of the battery, please consider
the collection systems or facilities for appropriate
recycling.
Effective Range of Remote Control Unit
When aiming the remote control toward the sensor on this
unit
(front or rear), ensure that the distance to the sensor
is within 7 m (23 ft).
If the remote control fails to work properly, move closer
to this unit.
30°
30°
20°
20°
Remote Control
This unit
Control through reflection off a screen, etc.
Ensure that the total of distance A (between this unit and
the screen) and distance B (between the remote control
and the screen) is within 7 m (23 ft).
*
As the efficiency of signals reflected from the remote
control unit varies with the type of screen used, the
operable distance may decrease.
20°
20°
Screen
Remote Control
This unit
18
Getting Started
To Next Page
Loading...
Need help?
General
