3
Turn off the power
Remote control: press the B [STANDBY] button
Projector unit: press the A button
0
While the “Are you sure you want to turn off?” message is displayed, press the button again.
0
The
light of the LD block goes off, and the “STANDBY/ON” indicator switches from a green light to a red blinking
light.
0
After the light goes off, the fan will run for approximately 10 seconds to cool down the LD block (Cool-down
mode). Do not disconnect the power cable while cooling is in progress.
0
Depending on the settings of the projector unit, cooling time may be about 30 seconds longer due to internal
processing.
0
After cooling is complete, the “STANDBY/ON” indicator switches from a blinking red to a solid red light.
In standby state
“STANDBY/ON” lights up (red)
In the Cool-down mode
“STANDBY/ON” blinking (red)
CAUTION
0
The power cannot be turned on again while cooling is in progress.
0
Pull out the power plug when the unit is not to be used for a prolonged period of time.
0
If
the indication of indicator differs from the description, refer to “Indicator Display on the Main Unit”P. 107 for details.
27
Operate
To Next Page
Loading...
General
