EN13
REC MODE – SP
LP
P
L
A
Y
O
F
F
MENU Wheel
Lock Button
Power lamp
Recording Mode Setting
Set the tape recording mode depending on your
preference.
1
Set the Power Switch to “ ” while pressing down
the Lock Button located on the switch, then open
the LCD monitor fully or pull out the viewfinder
fully. The power lamp lights and the camcorder is
turned on.
2
Press the MENU Wheel in. The Menu Screen
appears.
3
Rotate the MENU Wheel to select “ CAMERA”
and press it. The CAMERA Menu appears.
4
Rotate The MENU Wheel to select “REC MODE”
and press it. The Sub Menu appears. Select “SP” or
“LP” by rotating the MENU Wheel and press it.
Rotate the MENU Wheel to select “ RETURN”, and
press it twice. The Menu Screen closes.
•Audio Dubbing (Z pg. 66) and Insert Editing
(Z pg. 68) are impossible on a tape recorded in
the LP mode.
•“LP” (Long Play) is more economical, providing
1.5 times the recording time.
NOTES:
●
If the recording mode is switched during recording, the
playback picture will be blurred at the switching point.
●
It is recommended that tapes recorded in the LP mode
on this camcorder be played back on this camcorder.
●
During playback of a tape recorded on another
camcorder, blocks of noise may appear or there may
be momentary pauses in the sound.
Power Switch
Display
CAMERA Menu
Sub Menu
GR-DVM75 only
To Next Page
Loading...
Need help?
General
