EN45
P
L
A
Y
O
F
F
Night-Alive
Makes dark subjects or areas even brighter than they
would be under good natural lighting. Although the
recorded image is not grainy, it may look as if it is
strobing due to the slow shutter speed.
1
Set the Power Switch to “ ” while pressing down
the Lock Button located on the Switch. Open the
LCD monitor fully or pull out the viewfinder fully.
2
Press NIGHT-ALIVE so that the Night-Alive indicator
“ ” appears.
•The shutter speed is automatically adjusted to
provide up to 30 times sensitivity.
•“ ” appears beside “ ” while the shutter speed
is being automatically adjusted.
To Deactivate Night-Alive . . .
...press NIGHT-ALIVE again so that the Night-Alive
indicator disappears.
NOTES:
●
During Night-Alive, the following functions or settings
cannot be activated and its indicator blinks or goes out:
•
Some modes of “Program AE With Special Effects”
(
Z
␣ pg.␣ 46,␣ 47) and “Picture Wipe/Dissolve”
(
Z
␣ pg.␣ 48, 49).
•
“Snapshot Flash” (
Z
pg. 54).
•
“GAIN UP” in CAMERA MENU (
Z
pg. 39).
•
“DIS” in MANUAL MENU (
Z
pg. 39).
●
During Night-Alive, it may be difficult to bring the
camcorder into focus. To prevent this, use of a tripod is
recommended.
NIGHT-ALIVE Button
Power Switch
Lock Button
FOR RECORDING
To Next Page
Loading...
Need help?
General
