EN 53
Common Menus for All Modes
Menus
Settings ([ ] = Factory-preset)
墌
BASIC SETTING
Press 49 and then select sub menus.
–
PRESET
Returns all the camera settings
to their default values.
EXECUTE: Performs this function.
[CANCEL]: Returns to the menu screen without
executing reset.
–
DEMO MODE
Introduces special features of
the camera at the following
cases.
● When the menu screen is
closed.
● When there is no operation for
about 3 minutes after the power
switch is set to .
OFF: Disables the function.
[ON]: Activates the function.
NOTES:
● The demonstration only works when the DC cord is
connected, not with the battery.
● If an SD card is in the camera, demonstration will not
take place even if this mode is set to [ON].
–
OPERATION SOUND
Enables you to set the operation
sound or turn the operation
sound on/off.
OFF: Turns off the operation sound.
BEEP: The beep sounds when the power is turned on
or off, and at the beginning and end of recording.
[MELODY]: Instead of a beep, a melody sounds when
any operation is performed.
–
REMOTE
Turns reception of the operation
signal from the remote control
on/off.
OFF: The camera does not receive the signal from the
remote control.
[ON]: Enables operation with the remote control.
–
DROP DETECTION
Setting this function helps
prevent damage to the HDD by
enabling the camera to turn off
the power automatically when,
for example, it detects that it has
been dropped.
OFF: Disables the function.
[ON]: Activates the function.
To turn the unit on when the drop detection worked,
set the power switch to OFF, and to on again.
CAUTION:
Setting this function to off increases the chances of
damaging the built-in hard disk if the camera is
accidentally dropped.
–
MENU SETTINGS
M6E3Asia.book Page 53 Monday, March 13, 2006 3:03 PM
To Next Page
Loading...
Need help?
General
