EN 12
On-screen Language Selection
1
Press MENU. Then press ◀ or ▶ to select
“Setup”, then press ENTER.
OSD Language
Setup
Video Audio TV Setup Lock
English
Blue Screen
Time Setup
Subtitle
Off
Aspect Ratio
Auto
2
Press ▲ or ▼ to select “OSD Language”, then
press ◀ or ▶ to select the desired language.
3
Press RETURN to exit the menu.
Station search
Warning! All previously saved DVB-T channels
are deleted in Step 3. A new channel search
then starts automatically.
Preparation:
Make sure your antenna is connected to the
antenna input (see P.10). Select an appropriate
input mode. (See page 11). Then press MENU.
1
Press ◀ or ▶ to select “TV”,
then press
ENTER.
Press
▲ or ▼ to select “Tuner Mode”
.
Press ◀ or ▶ to select “Antenna” or “Cable” .
2
Press ▲ or ▼ select “Channels”, then press
▶
or ENTER.
3
Press ▲ or ▼ select “Channel Scan”, then
press
▶
or ENTER.
Press ◀ or ▶ to select desired country,
then
press ENTER.
Channel Scan
Channels
Video Audio TV Setup Lock
Analog Manual Scan
Digital Manual Scan
Channel Skip
Channel Sort
4
The Channel Scan will search for available TV-
channels and store the channels in the correct
order.
Cable : Search for Digital and Analogue channel.
You can select this option “Scan Mode: Quick/
Advance/Full”, then press ▲ or ▼ to select
“Scan” and press
▶
or ENTER.
- Quick: If TV find a channel of NIT1 (Network
Information Table), it will find all other channels
in NIT1. Don’t scan for the channels of other NIT.
(only for Germany, Finland and Norway)
- Full: TV will find all the channels of NIT1, NIT2,
NIT3...
- Advance: Define a frequency. Only search
channel in this frequency.
Scan Mode
Advance
Channel Scan
Video Audio TV Setup Lock
0%
Scan All Channels.
Frequency (KHz)
Scan
306000
Select
Antenna: Search for Digital and Analogue
channel.
Channel Scan Video Audio TV Setup Lock
6%
Status: Scanning...
Digital Channels: 7
Analog Channels: 0
5
When TV program have been stored 100%,
return to normal TV screen automatically.
Manual Channel Scan
Preparation:
Select “Analog Manual Scan” or “Digital Manual
Scan” in Step 3 of “Station search”.
Analog Manual Scan
Press ▲ or ▼ to select “Scan Up” or “Scan Down” to
start searching. Then press ▶ or ENTER.
Digital Manual Scan
Select RF Channel that you want to setup, then
press ENTER to start searching.
You can verify the signal strength and quality of
the selected service here. If necessary, adjust
the direction of the DVB-T antenna to obtain the
maximum signal strength.
J3LJ1351A.indb 12J3LJ1351A.indb 12 4/2/12 4:53:38 PM4/2/12 4:53:38 PM
To Next Page
Loading...
Need help?
General
