5 EN
LT-39HG48E
Important safety information
How to attach the stand
NOTE:
• Unplug the AC cord.
• Before performing work spread cushioning over the base area to lay the TV on.
• Do not support the TV by the screen as sharp objects and too much pressure may cause damage.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1) Place the TV on its front onto a table.
2) Align the stand’s base-plate (supplied) as seen here.
It will fit in only one direction. Make sure the locating pegs project through the locating holes.
3) Carefully hold the base plate in position and secure it with screws (4x16mm) LT-24HA48Ex3, LT-29HA48E/
LT-39HG48Ex4 (included).
Dismantling the base
For wall mounting, the base must be dismantled. To do this, remove screws (J, see page 10) from the back.
Take off the base entirely. Fit a VESA (LT-24HA48E/LT-29HA48E: 100x100mm, LT-39HG48E: 200x100mm)
wall mounting kit.
LT-24HA48E
LT-29HA48E
NOTE:
To detach the base plate, perform these steps in
reverse order.
•
Notes when mounting the TV on a wall
Before wall-mounting, please check carefully the location of the TV’s mounting-holes. (see, “Dimension”
on inside back cover)
•
J3NW2151A_EN.indd 5J3NW2151A_EN.indd 5 3/4/13 2:51:25 PM3/4/13 2:51:25 PM
To Next Page
Loading...
Need help?
General
