Available DSP modes will va W depending on how many speakers are used with this receiver.
Make sure that you have set the speaker intbrmation correctly (see page 14).
Front
speaker
Speaker arrangements
Front
speaker
/--\
Front TV Front
speaker speaker
Center speaker
Front
speaker
Rear )_)
speaker
TV / Front
speaker
_ Rear
speaker
Front
speaker
Front
[ Center speaker] speaker
Rear _ _ _ Rear
speaker speaker
Available DSP modes
Each time you press DSP MODE on the front panel or SURROUND MODE on
the remote control, the DSP modes change as follows:
• 3D THEATER
• LIVE CLUB
• DANCE CLUB
• HALL
• PAVILION
• 3D ACTION (or 3D DIGITAL)
• DSP OFF (DSP mode is canceled)
Each time you press DSP MODE on the front panel or SURROUND MODE on
the remote control, the DSP modes change as follows:
By pressing DSP MODE:
• THEATER (or DIG THEATER)
• LIVE CLUB
• DANCE CLUB
• HALL
• PAVtLION
• 3D ACTION (or 3D DIGITAL)
• DSP OFF (DSP mode is canceled)
To activate the Surround
mode, press DOLBY
SURROUND button so that the
lamp on the button lights up.
By pressing SURROUND MODE:
• DOLBY SURROUND
(DOLBY PRO LOGIC, DOLBY
DIGITAL)
• THEATER (or DIG THEATER)
• LIVE CLUB
• DANCE CLUB
• HALL
• PAVILION
• 3D ACTION (or 3D DIGITAL)
• DSP OFF (DSP mode is canceled)
To activate the Surround
mode, you can also use the
SURROUND ON/OFF button.
Note on the center speaker sound when using the DAP modes:
Sounds come out of the center speaker only if the following take place at
the same time;
• If "CENTER SPK" is set to "LARGE" or "SMALL."
• if the center channel signals come into this receiver ([_ of the signal
indicators lights up see page 10) while playing a multi_sound source
encoded with Dolby Digital.
In this case, you cannot adjust the center speaker output level.
22
To Next Page
Loading...
Need help?
General
