11
Wall Mounting
• Installation must be carried out by qualied personnel only. Incorrect assembly can result in severe
personal injury and property damage (if you intend to install this product yourself, you must check
for installations such as electrical wiring and plumbing that may be buried inside the wall). It is the
installer’s responsibility to verify that the wall will safely support the total load of the Soundbar and
wall brackets.
• Additional tools (not included) are required for the installation.
• Do not overtighten screws.
• Keep this instruction manual for future reference.
• Use an electronic stud nder to check the wall type before drilling and mounting.
1. Drill 4 parallel holes (Ø 3-8 mm each
according to wall type) in the wall.
The distance between the holes
should be 765 mm.
Dowel
Solid wall (i.e., Solid brick,
Solid concrete, Solid wood,
Solid wooden battens)
Drywall, Plaster wall,
Lath wall, etc.
2. Firmly x 1 dowel (included) into
each hole in the wall if necessary.
3. Tighten the wall mount brackets on
the wall with screws (included) and
screwdriver (not included). Make sure
that they are securely installed.
765 mm
4. Loosen the screws at the back of the
unit for 2 mm. Lift the unit onto the
wall mount brackets and slot into
place.
2 mm
765 mm
Loosen the screws
TH-W513B_IB_Final171124V5.indd 11 24/11/2017 3:58 PM
To Next Page
Loading...
Need help?
General
