8
Listening to the Radio
To set the AM tuner interval spacing
Before operating the tuner, it is required to select the
appropriate AM space interval used for your area.
1 Turn off the power.
2 Select the appropriate AM space interval for your
area.
• You can only use the button and the control on the front
panel.
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency stops changing.
• When you repeatedly press the button, the frequency
changes step by step.
• The frequency changes by kHz and MHz respectively for
AM tuner and FM tuner.
To stop searching manually,
press either button.
If the received FM station is not clear
The MONO indicator lights on the display. Reception will
improve though stereo effect is lost—Monaural reception.
To restore the stereo effect,
press the button again (the
MONO indicator goes off).
To preset the stations
You can preset 30 FM and 15 AM stations.
1 Tune in to a station you want to preset.
• You can also store the monaural reception mode for FM
preset stations if selected.
2 Activate the preset number entry mode.
• Finish the following process while the indication on the
display is flashing.
Remote control: Main unit:
INFO
Main Unit
ONLY
DOWN
4
AM 9KHZ
(9 kHz interval)
UP
¢
AM 10KHZ
(10 kHz interval)
(While holding...)
(While holding...)
TUNER
FM
TUNER
AM
AUX 1
FM/AM/
AUX
AUX 2
TUNER FM
TUNER AM
FM/AM
Remote control: Main unit:
GROUP/TITLE SKIP
0.5 sec.
DOWN
UP
0.5 sec.
Remote
ONLY
REV.MODE
FM/PLAY MODE
Remote
ONLY
CANCEL
SET
UX-AD8[A].book Page 8 Tuesday, November 22, 2005 1:59 PM
To Next Page
Loading...
Need help?
General
