8
Listening to the FM/AM Radio
• For DAB operations, see page 18.
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
Station searching starts and the frequency indication starts
changing on the display.
When a station (frequency) with sufficient signal strength is
found, the searching stops.
• When you press the button repeatedly, the frequency
changes step by step.
• While receiving FM stereo stations with sufficient signal
strength, the ST indicator lights.
To manually stop searching,
press either button.
If the FM station reception is poor
Reception will improve though stereo effect is lost—
Monaural reception.
To restore the stereo effect,
press the button again.
If the beats are heard while listening
to AM station
Select from “BEAT CUT 1” to “BEAT CUT 4,” whichever
reduce the beats.
To preset the stations
You can preset 30 FM and 15 AM stations.
1 Tune in to a station you want to preset.
• You can also store the monaural reception mode for
FM preset stations if it is selected.
2 Activate the preset number entry mode.
• Finish the following process while the indication on the
display is flashing.
3 Select a preset number for the station you store.
4 Store the station.
To tune in to a preset station
1
Select the band (FM or AM).
2 Select the preset number for the station you stored.
INFO
FMDAB
AM
AUX
2 sec.
Decreases the frequency.
Increases the frequency.
Remote
ONLY
Remote
ONLY
BEAT CUT 1 BEAT CUT 2
BEAT CUT 3BEAT CUT 4
Examples:
To select preset number 5, press
5.
To select preset number 10, press
10.
To select preset number 15, press
10, 1, then 5.
To select preset number 30, press
10, 3, then 0.
Examples:
To select preset number 5, press
5.
To select preset number 10, press
10.
To select preset number 15, press
10, 1, then 5.
To select preset number 30, press
10, 3, then 0.
Remote
ONLY
Remote
ONLY
FMDAB
AM
AUX
UX-DM9[B].book Page 8 Friday, July 20, 2007 2:18 PM
To Next Page
Loading...
Need help?
General
