– 10 –
Tuning In a Station
1 When the unit is turned on,
press TUNER/BAND to
select tuner mode.
The unit tunes in the last station
tuned in (either FM or MW).
2 Press TUNER/BAND to
select the band, FM or MW.
Each time you press the button, the
band selection alternates between
FM and MW.
3 Press and hold 4 or ¢
for more than 1 second.
The unit starts searching for stations
and stops when a station of sufficient
signal strength is tuned in.
If a program is broadcast in stereo,
the STEREO indicator lights up.
To stop searching, press 4 or ¢.
When you press 4 or ¢ briefly and repeatedly
The frequency changes step by step.
Presetting Stations
You can preset 20 FM and 20 MW stations.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1 Tune in the station you want to preset.
• See “Tuning In a Station” on the left.
2 Press PROGRAM.
The PROGRAM indicator and “00”
start blinking on the display.
3 Press PRESET ∞ or 5 (or
PRE UP or REPEAT/PRE
DOWN on the remote
control) to specify the
desired preset number.
4 Wait a few seconds to confirm the preset
number.
• Alternatively, press PROGRAM.
5 To preset more stations, repeat the steps
above, allocating a different preset number to
each station.
When a new station is stored
The station previously memorized with the same preset
number is erased. (The frequency of the new station replaces
the previous frequency in memory.)
Listening to FM and MW Broadcasts
Continued
TUNER
BAND
TUNER
BAND
SEARCH/TUNING
PROGRAM
PRESET
REPEAT
02_01_21_UXM3R_A_En.p65 02.1.21, 7:23 PM10
To Next Page
Loading...
Need help?
Amplifier Specifications
