JVC UX-M3R User Manual

– 15 –
Playing Back Tapes
• Use only type I normal tapes.
The use of tapes longer than 120 minutes is not
recommended, since characteristic deterioration may
occur and these tapes easily jam in the pinchroller and
the capstan.
Loading a Tape
1 Press 0 EJECT to open the
tape deck door.
2 Insert a recorded tape with the open side
down and playback side facing out from the
unit.
3 Close the tape deck door.
The TAPE indicator appears on the display.
Tape Playback
1 When the unit is turned on,
press TAPE.
2 Press 6.
Playback starts.
“PLAY” and the 3 indicator appear
on the display.
3 To stop playback, press 7.
To interrupt playback
Press 6.
The 3 indicator starts blinking and
“PAUSE” appears on the display.
To resume playback, press 6 again.
Rewind/Fast Forward
1 Press 4 or ¢ to rewind
or fast forward the tape.
“REW” or “FF” appears on the
display.
2 Press 7 to stop rewinding or
fast forwarding.
• The tape stops automatically at the end of the rewinding or
fast forwarding.
EJECT
TAPE
PLAY/PAUSE
STOP/CLEAR
PLAY/PAUSE
SEARCH/TUNING
STOP/CLEAR
02_01_21_UXM3R_A_En.p65 02.1.21, 7:24 PM15

JVC UX-M3R Specifications

Amplifier Specifications

output power	24 W (12 W + 12 W) at 8 Ω (MAX.)
output power at THD	20 W (10 W + 10 W) at 8 Ω (10% THD)
audio output level	800 mV/32 Ω
speakers impedance	8 Ω - 16 Ω

Tuner Specifications

FM tuning range	87.50 MHz - 108.00 MHz
MW tuning range	522 kHz - 1 629 kHz

CD Player Specifications

dynamic range	60 dB
signal-to-noise ratio	60 dB
wow and flutter	Unmeasurable

Cassette Deck Specifications

frequency response for normal tape	100 Hz - 10 000 Hz
wow and flutter	0.35% (WRMS)

General Specifications

power requirement	AC 240 V, 50 Hz
power consumption (operation mode)	30 W
power consumption (standby mode)	1.5 W
dimensions	160 mm × 269.5 mm × 300 mm
mass	4.3 kg

Speaker Specifications

speaker unit (woofer)	10.2 cm cone × 1
speaker unit (tweeter)	5.1 cm cone × 1
impedance	8 Ω
dimensions	160 mm × 269.5 mm × 192 mm
mass	2 kg/each