Kärcher RCV 3 User Manual

14 English
b Push the wiper cloth holder hori-
zontally into the cleaning robot un-
til it audibly engages.
Removing the wiper cloth holder
with wiper cloth
1. Press any key.
The cleaning robot stops.
2. Remove the wiper cloth holder.
a Press the clamps together.
b Remove the wiper cloth holder.
c Pull the wiper cloth off the wiper
cloth holder.
Installing the dust container
Insert the dust container if you want to
clean dry only.
Remove the wiper cloth and wiper
cloth holder for dry cleaning, see chap-
ter Removing the wiper cloth holder
with wiper cloth.
1. Open the cover at the top.
2. Press the dust container into posi-
tion until it audibly clicks into place.
3. Close the cover at the top.
Removing the dust container
1. Open the cover at the top.
2. Press the clamp.
3. Remove the dust container.
Resetting the WLAN connection
If you switch to a new router or change
your WLAN password, you must reset
the cleaning robot's WLAN connection.
Note
Only 2.4 GHz WLAN networks are sup-
ported.
1. Switch on the cleaning robot, see
chapter Switching on the cleaning
robot.
2. Press the On / Off button and the
"Return to charging station" button
simultaneously for 7 seconds until a
voice says: "Resetting the WLAN
connection and entering the network
configuration mode".
3. Connect the cleaning robot to the
charging station, see chapter Con-
necting the cleaning robot to the
charging station.
Restoring the factory settings
1. Press and hold the "Back to
charging station" button for 5 sec-
onds until a signal sounds.
2. Press and hold the "Return to
charging station" button again for 5
seconds until a signal sounds.
The factory settings are restored.

Kärcher RCV 3 Specifications

General

Product type	Accessory kit
Brand compatibility	Kärcher
Suitable for vacuum cleaner type	Robot vacuum
Number of pads	1
Number of brushes	3
Number of filters	2 pc(s)
Quantity per pack	6 pc(s)
Package weight	400 g

Weight and Dimensions

Depth	190 mm
Width	125 mm
Height	82 mm
Weight	100 g