Keba KeMes A1 Series User Manual

A2xxOperation and handling
Operating instructions V1.01
22
© KEBA
Fig.5-8: Examples of positioning using the upper tool
5.3 Measurability
The materials and surfaces of workpieces used in practice are highly varied,
meaning that the manufacturer cannot make exhaustive suitability specifica-
tions despite extensive test series. Therefore, before carrying out qualified
measurements, the user must check for suitability and sufficient accuracy of
the measured object for the specific purpose in combination with the respec-
tive materials and usage conditions.
The following tables provide an overview of the most frequently occurring
workpieces in practice. To be able to execute a measurement, both the ma-
terial as well as the surface of the workpiece must be suitable for the mea-
surement.
Material Easy to measure
Not measurable / hard to
measure
1)
Aluminum x
Steel x
Stainless steel x
Galvanized sheets x
Non-metallic materials x
1)
These materials usually cannot be measured or can be measured only
with limited accuracy.
Surface Easy to measure
Not measurable / hard to
measure
2)
Smooth surface x
Sheets with protective foil x
Clean surface x
(Heavily) scaled sheets x
Electrolytically galvanized sheets
for machine reading
x
Painted sheets x
Enameled sheets x
Pickled surface x
Mechanically treated surface
3)
:

Keba KeMes A1 Series Specifications

General

Brand	Keba
Model	KeMes A1 Series
Category	Measuring Instruments
Language	English