3. Fuel level is improperly set Check and replace
4. Throttle valve is not operating properly Check throttle valve for operation
5. Fuel filter is clogged Check and clean
3 Overflow and fuel level 1. Needle valve is wom or damaged Replace
fluctuations 2. Spring in needle valve is broken Replace
3. Float is not working properly Check and adjust
4. Needle valve is blocked Clean
5. Fuel level is too high or low Adjust aocordingly
BRAKES
1 I nsufficientbiake Dower 1. Leakage of brake fiuid from hydraulic system Repair or replace
2. Wom pads Replace
3. Oil adhesion on engaging surface of pad Clean disc and pads
4. Wom disc Replace
5. Air entered into hydraulic system Bleed air
6. Wom shoe Replace
7. Friction surfaces of slJQes are dirty with oil Replace
8. Excessivelywom drum Replace
9. Too much brake lever play Adjust
2 Brake Squeaking 1. Carbon adhesion on pad surface Repair surface with sand paper
2. Tilted pad Modify and fit
3. Damaged wheel bearing Replace
4. Wom pad Replace
5. Foreign substance entered into brake fluid Replace brake fluid
6. Clogged retum port of master cylinder Disassemble and clean
7. Brake shoe surface glazed Repair surface wit/:1 sand paper
8. Loose front wheel axle or rear wheel axle Tighten to specified torque
To Previous Page
Loading...
Need help?
General
