Keithley 263 Quick Reference Guide

IBM PC or AT
(CEC PC < > 488 Interface)
The following program sends e command string to the
Model 263 from an IBM PC or AT computer end displays
the instrument reading string on the CRT. The computer
tnuet be equipped with the CEC lnterfaos and the DOS 2.00
lx later revisicnl cpereting system.
DIRECTIONS
1. Using the front panel prcgrem feature, set the primary
address of the Model 263 to 9.
2. With the power off, connect the Model 263 to the
IEEE-499 interface installed in the IBM computer.
3. Type in SASICA on the computer keyboard to get into
the IBM interpretive BASIC Ienguage.
4. Enter the lines below using the return key after eech line.
6. Run the program and type in the desired command string.
For example, to place the instrument in the current func-
tion end ZOO,& range, type in FIRSX and press the return
key.
6. The instrument reading string will then appear on the
dlsplsy.
24

Keithley 263 Specifications

General

Brand	Keithley
Model	263
Category	Test Equipment
Language	English