Keithley 263 Quick Reference Guide

APPLE II
(Apple II IEEE-488 interface)
The following program sends a command string to the ;
Model 263 from an Apple II computer and displays the in-
strument reading string on the computer CRT.
The computer must be equipped with the Apple II IEEE-466
Interface installed in slot 3.
;
i,
DIRECTIONS
_~I
1. Using the front panel program feature. set the primary 1~ 1 ‘:
address of the Model 263 to 6.
2,With the power off, connect the Model 263 to the j !
IEEE-466 interface installed in the Aoole II computer.
3. Enter the lines in ths program below, &ins the FliTURN
key after each line.
4. Run the program and tvps in the desired command String
at the command prompt. For example, to place the in-
strumsnt in the current function and 200pA range. type
in FtRgX and press the return key.
6. The instrument reading string will then appear on the
CRT.
26

Keithley 263 Specifications

General

Brand	Keithley
Model	263
Category	Test Equipment
Language	English