Self-Cleaning
• Setting Flex Clean
• Setting Delay Flex Clean
INSTRUCTIONS
When the Self=Clean cycle is done:
1. The time of day,"Not, DOOR LOCKED" and "CLEAN" icon will
remain in the display (See Fig. 7).
2. Once the oven has cooled down for approximately 1 HOUR, and
the "DOOR LOCKED" icon is no longer displayed, the oven
door can then be opened.
PRESS DISPLAY
Fig.7
Stopping or Interrupting a Self=Cleaning cycle:
If it becomes necessary to stop or interrupt a Self-Cleaning cycle
due to excessive smoke or fire in the oven:
1. Press_.
2. Once the oven has cooled down for approximately 1 HOUR and
the "DOOR LOCKED" icon is no longer displayed,the oven door Fig.8
can then be opened (Fig. 8).
IMPORTANT NOTES when using the Self-Clean feature:
1. Do not use the surface burners after setting for a Self-Clean cycle.
2. A Self=Clean cycle cannot be started if Oven Lockout feature is active.
3. If a Self-Cleaning-Cycle has started but not finished and a power failure occurs, the appliance may not have thoroughly
cleaned. Once power is restored, set for another Self-Clean cycle to finish.
4. If your clock is set for normal 12 hour display mode the Delay Self=Clean cycle can never be set to start more than 12
hours in advance. To set for Delay Flex-Clean 12-24 hours in advance see page 13 for instructions to set the control for the
24 hour time of day display mode.
iii..............
..........iii.........
33
To Next Page
Loading...
Need help?
General