Kenner KNL100E-01 User Manual

12.
Open the release hole plug on the top of the gate opener, insert the release key, and turn the key 90°
counterclockwise. This restores normal operation.
Mounting of the
control box
Remove the cover of the control box and use 4 deck
(
not provided) to install the control box.
box is installed in a secure surface and at least 100 cm (40
inches) above the ground to protect it from rain, snow, etc.
wh
ich probably cause damage to the control box.
Connection of the P
ower
The gate opener can be powered by 24V 12Ah battery (NOT INCLUDED) OR
supply (NOT INCLUDED) with minimum output power 150W.
ONLY used to charge the battery.
Instead of using a battery, the AC
save the cost where AC electricity is accessible
and stable.
If batteries
are chosen as the power source,
Marine or Automotive Type Battery with
capacity greater than 7
Ah is required. The
batteries should be waterproof type, or be
placed in water proof circumstance.
2 PCS 12VDC batteries can be connected in
series to function
as 24VDC. The following
diagram shows on how to connect 2 PCS
batteries in series. Charging mode for the
battery could be by the adapter, by the solar panel, or both of them at the same time.
11
Open the release hole plug on the top of the gate opener, insert the release key, and turn the key 90°
counterclockwise. This restores normal operation.
control box
Remove the cover of the control box and use 4 deck
screws
not provided) to install the control box.
Ensure the control
box is installed in a secure surface and at least 100 cm (40
inches) above the ground to protect it from rain, snow, etc.
ich probably cause damage to the control box.
Supply
The gate opener can be powered by 24V 12Ah battery (NOT INCLUDED) OR
supply (NOT INCLUDED) with minimum output power 150W.
The adapter included in the packag
Instead of using a battery, the AC
-
DC Power Supply is highly recommended as the power source to
save the cost where AC electricity is accessible
are chosen as the power source,
Marine or Automotive Type Battery with
Ah is required. The
batteries should be waterproof type, or be
placed in water proof circumstance.
2 PCS 12VDC batteries can be connected in
as 24VDC. The following
diagram shows on how to connect 2 PCS
batteries in series. Charging mode for the
battery could be by the adapter, by the solar panel, or both of them at the same time.
Open the release hole plug on the top of the gate opener, insert the release key, and turn the key 90°
The gate opener can be powered by 24V 12Ah battery (NOT INCLUDED) OR
a 24VDC AC-DC power
The adapter included in the packag
e is
DC Power Supply is highly recommended as the power source to
battery could be by the adapter, by the solar panel, or both of them at the same time.

Kenner KNL100E-01 Specifications

General

Brand	Kenner
Model	KNL100E-01
Category	Gate Opener
Language	English